Romilly's HART® and Fieldbus Message Board

dll testing on htest & analys

Dear sir,
I passed 36 DLL tests on HTEST & ANALYS set up but 8 DLL test failed. i am not understanding where is problems.details of failure reports as follows :

1) for test DLL 034 :
Failure message: insufficient STX's detected.failure point == 354

2) for test DLL 032 :
Failure message: test spec requires at least 64 STX commands.failure point == 348

3) for test DLL 033c :
Failure message: test spec requires at least 4 STX's commands.failure point == 352

4) for test DLL 029 :
Failure message: response time is < RT1.failure point == 846,847,848.

5) for test DLL 028 :
Failure message: 291 messages captured are insufficient .failure point == 396

6) for test DLL 027 :
Failure message: BACK RESPONSE TIME < RT2.failure point == 839

7) for test DLL 026 :
Failure message: cmd2 always answers busy.failure point == 431
500 messages captured are insufficient.failure point == 395

8) for test DLL 024b :
Failure message: 249 messages captured are insufficient.failure point == 426

please guide me to solve above problems.(problem in s/w, test setup, system configuration & state machine timing).
Thanking you.
Regards
Abhishek Patel
Devlopment engineer

Follow Ups:

• Re: dll testing on htest & analys Roy Mulder 2013/11/10 23:11:05 (0)

Post a Followup